90 REDIRECTED DEVICE TABLE FULL

    Problem : This status code is applicable only in the server-based environment.

BREQUEST's redirection table or server routing table was full. This occurs if you attach to additional servers or map to additional drives after you loaded BREQUEST. 

This error also occurs if you detach a particular server and attach to a different server. Once a workstation has attached to a server, BREQUEST will not remove its name from the server routing table.

    Solution : Reload BREQUEST, specifying a larger number for the "Number of File Servers" or "Number of Mapped Drives" options (IS and IR respectively).

91 SERVER ERROR

    Problem : This status code is applicable only in the server-based environment.

BREQUEST could not establish a session with the server. In NetWare environments, either the NetWare Btrieve Record Manager has not been started or the server was not active. 

    Solution : Verify that the NetWare Btrieve Record Manager is active on the server in question.

92 TRANSACTION TABLE FULL

    Problem : This status code is applicable only in tbe server-based environment.

The maximum number of active transactions was exceeded. 

    Solution : Reconfgure Btrieve and specify a higher value for the "Number of Concurrent Transactions" option.

93 INCOMPATIBLE LOCK TYPE

    Problem : 

    Solution : 

94 PERMISSION ERROR

    Problem : Your application tried to open or create a file in a directory without the proper privileges. Btrieve does not override the network privileges assigned to users.

    Solution : Contact you network systems administrator.

95 SESSION NO LONGER VALID

    Problem : This status code is applicable only in the server-based environment.

The previously established session was no longer active due to an error at the workstation, the file server, or on the network. 

    Solution : Verify that your workstation is still attached to the file server and then reload BREQUEST.

96 COMMUNICATIONS ENVIRONMENT ERROR

    Problem : This status code is applicable only in the server-based environment.

This code occurs when loading Btrieve on a NetWare server. The SPX connection table is full. 

    Solution : Reload SPX, specifying a higher value for the connection table. Refer to the NetWare system documentation for move information.

97 DATA MESSAGE TOO SMALL

    Problem : This status code is applicable only in the server-based environment.

Your application tried to read or write a record which was longer than the Btrieve Record Manager or BREQUEST could handle. 

    Solution : Reconfigure the Btrieve Record Manager and specify a higher value for the "Maximum Record Length" option. 

Reload BREQUEST and specify a higher value for the /D option.

98 INTERNAL TRANSACTION ERROR

    Problem : This status code is applicable only in the server-based environment.

An error has been detected while executing a previous operation on a NetWare file. 

    Solution : Contact you network systems administrator.