11 INVALID FILENAME

    Problem : The filename specified does not conform to file naming conventions.

    Solution : 

12 FILE NOT FOUND

    Problem : The filename specified does not exist. Check the key buffer parameter to make sure the pathname is terminated with a blank or a binary zero.

    Solution : 

14 PRE-IMAGE OPEN ERROR

    Problem : The pre-image file could not be created or opened. There are three possible causes for this error.

· Btrieve could not create a new pre-image file because your disk directory is full. Btrieve must be able to create a pre-image file.

· Btrieve could not open the pre-image file to restore file integrity. If the pre-image file was erased or damaged, Btrieve cannot restore the file's integrity. In this case, either use the RECOVER command in the BUTIL utility to retrieve the damaged file's data records in a sequential file, or replace the file with its most recent backup.

· Btrieve could not assign a handle to the pre-image file because the Btrieve was not started by a user with access rights to the pre-image file.

    Solution : 

15 PRE-IMAGE I/O ERROR

    Problem : An I/O error occurred during the pre-imaging function. Either the disk is full or the pre-image file is damaged.

· If the disk is full, erase any unnecessary files or extend the file to gain additional disk space.

· If the pre-image file is damaged, the integrity of the Btrieve file cannot be ensured. Either use the RECOVER command in the BUTIL utility to retrieve the damaged file's data records in a sequential file, or replace the file with its most recent backup.

Notes:· Novell Netware

If you get this error running on a Novell server, run the Novell Purge procedure. Novell stores invisible files which will eventually fill up your disk drive even if doing a directory on the drive shows millions of bytes left.

    Solution : 

17 CLOSE ERROR

    Problem :An error occurred while writing the directory structure to disk prior to closing the file. Either Btrieve could not close the file, or a new page was added to the file and Btrieve could not close and reopen the file to update the directory structure. Check for a disk hardware failure. This status code also occurs if the application passed an invalid position block for the file. 

    Solution : 

18 DISK FULL

    Problem : The disk is full and the file could not be expanded to accommodate the insertion. Either erase any unnecessary files or extend the file to gain additional disk space.

    Solution : 

19 UNRECOVERABLE ERROR

    Problem : An unrecoverable error has occurred. File integrity cannot be ensured.

Either use the RECOVER command in the BUTIL utility to retrieve the damaged file's data records in a sequential file, or replace the Btrieve file with its most recent backup.

    Solution :